BG Motor has been a DC motor manufacturer and AC motor supplier for 30+ years.

BL2406 motor driver manufacture

Model Number:BL2406 Brushless Motor Drive

Output current: 3-8A

Range of Voltage:12-24VDC

Range of Rated Speed: 150-30000rpm

Size:60*45*33 Unit MM

Lifespan:/

Description

II. Technical parameter specifications

Projects	Minimum value	Typical values	Maximum value	Unit
Input voltage	12	12	24	V DC
Output current	3	6	8	A
undervoltage protection		10		VDC
Overpressure protection		30		VDC
Speed control	150	3000	30000	Rpm
Weight	0.28 KG
Size	604533 Unit MM
Control mode	Square waves
Speed regulation mode	0- 5 VDC analog input, 0- 100% PWM input (PWM frequency range :[1 Kz-20KHz)
Over-current protection function	Overcurrent protection occurs when the current exceeds the operating current setting value and lasts a set time
Overpressure	An overvoltage protection occurs when the voltage exceeds 30 V
undervoltage	undervoltage protection when voltage is below 10 V
Hall anomaly	Hall signal anomaly

III. Digital control signal port

Name	Note
DC+/DC-	DC voltage input (DC 10V~DC 24V)
U,V,W	Motor Phase Line
Hu,Hv,Hw	Hall signal
VCC	Hall Power +
SV	External speed regulation. suspended when using internal speed regulation.
F/R	Direction,suspendedorhighatnormaltimespositiveturn, low level reverse.
EN	Control signal enable high level stop, low level run
BRK	Brake, low power normally for normal operation, high level shutdown
ALARM	Alarm signal output

Mechanical Dimensions

Ⅰ. Drive mounting dimensions

$8N{_IBM)BDV@VIKH_3R(IPL (2)$

8N{_IBM)BDV@VIKH_3R(IPL (2)

$8N{_IBM)BDV@VIKH_3R(IPL (2)$

8N{_IBM)BDV@VIKH_3R(IPL (2)

IV. Interface Function Description

Boot and Stop (EN)

the motor runs itself after the driver is powered on.

The stop of motor can be controlled by connecting EN end and DC- end. The control logic level can be reversed by the upper computer.

The switch of motor start and stop can be realized by connecting switch between DC- and EN or using PLC to control its on-off.

Fast Stop (BRK)

the motor runs itself after the driver is powered on.

connecting BRK end and DC- end can control motor fast brake stop. The control logic level can be reversed by the upper computer.

The switch between motor start and brake can be realized by connecting switch between DC-and BRK or using PLC to control its on-off.

Direction control (DIR)

After the driver is powered on, the motor runs according to the DIR setting.

The motor reversing can be controlled by connecting the DIR end and the DC- end. The control logic level can be reversed by the upper computer.

The motor direction switch can be realized by connecting the switch between DC- and DIR or using PLC to control its on-off.

Note: From the direction of the motor shaft, the motor shaft turns

clockwise and vice versa.

Get In Touch With Us

Just leave your email or phone number in the contact form so we can send you a free quote for our wide range of designs!